This section describes how to add a new
SATA disk to a machine that currently only has a single drive.
First, turn off the computer and install the drive in the computer following the instructions of the computer, controller, and drive manufacturers.
Reboot the system and become
to ensure the new disk was found.
In this example, the newly added
SATA drive will appear as
For this example, a single large partition will be created on the new disk.
GPT partitioning scheme will be used in preference to the older and less versatile
If the disk to be added is not blank, old partition information can be removed with
The partition scheme is created, and then a single partition is added. To improve performance on newer disks with larger hardware block sizes, the partition is aligned to one megabyte boundaries:
# gpart create -s GPT ada1 # gpart add -t freebsd-ufs -a 1M ada1
Depending on use, several smaller partitions may be desired. See gpart(8) for options to create partitions smaller than a whole disk.
The disk partition information can be viewed with
% gpart show ada1=> 34 1465146988 ada1 GPT (699G) 34 2014 - free - (1.0M) 2048 1465143296 1 freebsd-ufs (699G) 1465145344 1678 - free - (839K)
A file system is created in the new partition on the new disk:
# newfs -U /dev/ada1p1
An empty directory is created as a mountpoint, a location for mounting the new disk in the original disk’s file system:
# mkdir /newdisk
Finally, an entry is added to
so the new disk will be mounted automatically at startup:
/dev/ada1p1 /newdisk ufs rw 2 2
The new disk can be mounted manually, without restarting the system:
# mount /newdisk